Kambrook 4 Kingston Town Close Oakleigh,Victoria 3166,Australia
Customer Service Line (free call) 1800 800 634 Customer Service Fax 1800 621 337
Kambrook (New Zealand) Mono Place Ellerslie,Auckland, New Zealand
Customer Service Line/Spare Parts 0800 253 007 Customer Service Fax 0800 263 001
Essentials
Can Opener
Due to continual improvement in design or otherwise, the product you purchase may differ slightly from the one illustrated in this book. Issue 1/04
KEC10
Issue 1/04
USINGYOUR KAMBROOK
ESSENTIALS CAN OPENER
1. Before use, always ensure that the
cutter assembly and magnetic lid holder
are correctly positioned (See Fig 1).
CARE AND CLEANING
Fig 2
CAUTION : Be careful when
removing the lid from the magnet, as
the cut edge is sharp.
Your Kambrook Essentials Can Opener is
designed so that the cutter assembly
removes for easy cleaning.
Dented/damaged cans: Occasionally, badly
dented cans will cause the Essentials Can
Opener to stall. If this happens, grasp the
dented can and guide it through the
cutting action manually until the damaged
areas are open.
To ensure best performance keep the
cutter assembly clean.
Fig 1
Turn the power off and unplug the cord
from the power outlet before cleaning.
Remove the cutter assembly by raising the
lever to its most upright position, and
sliding it towards you.
Jammed cans:To continue opening a can
that has become jammed, raise the
control lever and release the can. Begin
cutting the can again in a new position on
the can lip.
4.Whilst holding the can, firmly press the
control lever down, piercing the lid of
the can.This holds the can and starts
the cutting action. Ensure the magnetic
lid holder is in contact with the lid of
the can.
Drive Wheel:
Wipe with a damp cloth to thoroughly
clean; use a small brush to remove
accumulated dirt.
The cutter assembly fits into the
keyhole opening at the top of the
Essentials Can Opener, above the drive
wheel. Ensure that the post is pushed all
the way into the keyhole and that the
control lever is pressed firmly against
the Essentials Can Opener body.
Position the magnetic lid holder up or
down until it is in a horizontal position
(Fig 1).
Motor Housing:
5.When the can begins to turn, it is no
longer necessary to hold down the
control lever.
Wipe over with a damp cloth.
Do not use harsh abrasives or cleaners to
clean any parts of your Essential Can
Opener, as these may scratch the parts.
6.When the can is fully open, the
Essentials Can Opener will stop
automatically.
Do not wash any parts in a dishwasher, as
the hot water temperatures and harsh
detergents may ultimately warp and
scratch these parts.
7.To remove cans, support the can with
one hand and lift the control lever with
your thumb on your other hand.The lid
will remain attached to the magnetic lid
holder (Fig 3).
2. Insert the two pin plug into a 230/240
volt power outlet and turn the power on.
NEVER IMMERSETHE
ESSENTIALS CAN OPENER OPEN
IN WATER OR OTHER LIQUID.
3. Hold the control lever in the upright
position. Position the can under the
support bar so that the rim of the can
rests on top of the drive wheel, tilting
the can at a slight angle towards the
main body of the unit (Fig 2).
Fig 3
4
5
Notes
KAMBROOK
12 MONTH
REPLACEMENT WARRANTY
If the product includes one or a number
of accessories only the defective accessory
or product will be replaced.
KAMBROOK warrants the purchaser
against defects in workmanship and
material, for a period of 12 months from
the date of purchase (3 months
commercial use).
In the event of KAMBROOK choosing to
replace the appliance, the guarantee will
expire at the original date, ie. 12 months
from the original purchase date.
Guarantee and purchase receipt for this
product are to be retained as proof of
purchase and must be presented if making
a claim under the terms of the
In Australia, this KAMBROOK Guarantee
is additional to the conditions and
guarantees which are mandatory as
implied by the Trade Practises Act 1974
and State Territory legislation.
KAMBROOK guarantee.
KAMBROOK reserves the right to
replace or repair the appliance within
the warranty period.
For service, spare parts or product
information in Australia, please call
KAMBROOK on the customer Service
Line (free call) 1800 800 634.
Warranty does not apply to any defect,
deterioration, loss or injury or damage
occasioned by, or as a result of the misuse
or abuse, negligent handling or if the product
has not been used in accordance with the
instructions.The guarantee excludes
For service, spare parts or product
information in New Zealand, please
call KAMBROOK New Zealand, Mono
Place, Ellerslie,Auckland.
breakages and consumable items such as
kneading blades and mixing containers.
Phone 0800 253 007, FAX 0800 263 001.
This warranty is void if there is evidence
of the product being tampered with by
unauthorised persons.
If claiming under this guarantee the product
must be returned to freight prepaid.
YOUR PURCHASE RECORD (Please complete)
Attach purchase receipt here.
DATE OF PURCHASE___________________________
MODEL NUMBER _____________________________
SERIAL NUMBER (If applicable) ___________________
Please don’t return purchase record
unless you are making a claim
PURCHASED FROM ___________________________
Issue 1/04
6
|